-
-
Abbot自行火炮是作为WW2时代的SextonSPG的快速、轻便替代品而开发的火力支援榴弹炮。它由一门105毫米榴弹炮组成,安装在FV430系列车体顶部的完全可穿越的炮塔中。SPG的VE(价值工程)版本是为印度制造的更便宜的型号,没有原始版本的一些高级功能,例如NBC保护设备、浮选屏幕、动力枪操作或通信。...
-
-
制作定向地图制图|OCAD 11.5.6.2031
安装过程:
1,安装OCAD_11_Trial_Setup.exe
2,覆盖 OCAD 11 Trial.exe 和 OCAD 11 Trial License.xml
激活的时候填一堆东西,然后就搞定了
-
改良型A2 /O工艺的脱氮诊断分析
随着污水排放标准不断提高, 基于污水厂现状的A2 O 工艺的脱氮诊断和优化, 是解决脱氮问题最为经济也是优先采取的方案。以昆山市北区污水厂为
-
-
低溶解氧对改良A/A/O 工艺脱氮除磷的影响
以采用厌氧/缺氧/好氧( A/A/O) 工艺的城镇污水处理厂为研究对象,利用改良A/A/O 中试装置开展处理实际污水
的研究,通过与实际工艺的运行效果对比,系统探讨了低溶解氧( DO) 浓度以及好氧池末端非曝气区的设置对脱氮除磷的影响。
-
天津信托大厦的波动分析研究
本文对天信大厦的明显波动现象进行了现场测试,通过对数据的分析,给除了外部震源确定方法,揭示了预应力混凝土板—钢管混凝土柱的板柱结构的波动特性,并且对大厦的防震隔震给除了建议。
-
A2/O 生物脱氮除磷工艺中氧化沟的设计
本设计即采用了众多脱氮除磷工艺中较为经济合理的A2/O 工艺对进入污水厂的污水进行处理。设计污水处理厂处理所在城市生活污水,日处理能力10万方,有效去除水中BOD、SS以及氮、磷元素,出水质量将达到国家污水综合排放标准二级标准。本设计对污水处理厂处理流程、处理构筑物、以及高程进行了初步设计。
-
在现代化工厂的自动控制中,调节阀起着十分重要的作用,这些工厂的生产取决于流动着的介质正确分配和控制。这些控制无论是能量的交换、压力的降低或者是简单的容器加料。...
-
STM_O系列螺旋斜齿轮箱和齿轮电机12款类型:斜齿,螺旋齿轮机轴位置:正交性能:高刚性其他特性:工业旋转速度:最少:0rpm(0rad.min-1)最多:10,500rpm(65,973.45ra...
-
-
英国PEM 罗氏线圈柔性电流探头 CWT系列
深圳市宏美瑞科技有限公司为您介绍PEM罗氏线圈电流探头:
CWT系列交流电流探头是实实在在为您解决电力电子的电流测量问题的转换工具:
高带宽、大容量的测量范围,配合高质量的测量指标,保证您的测量要求;纤细、柔软的感应套环,让您轻而易举地与实际测量对象相连接。
主要特点:
测量范围:300mA~300,000A;
典型带宽:1Hz~13MHz;
纤细、柔软的高性能感应套环:
近乎为零的干扰:在测量过程中,实际负载电流仅为几个皮亨;
轻而易举地与实际的测量对象相连接;
感应套环的峰值电压绝缘能力可达10KV;
感应套环周长由300mm~1000mm,超出该范围的,可根据顾客的实际需求定制;
瞬时电压的输出为峰—峰值±6V,可以直接与示波器、数据采集设备、数字电压表以及电力记录设备相连接,也可以作为触发输出;
精度可达1% 。
-
A/A/O 系统物料流向及平衡的影响因素再分析
在《A/A/O 系统物料流向及平衡的影响因素分析》对中试A/A/ O 系统进行了不同温度及内(混合液)回流比的三种工况下的COD、N、P 在各个构筑物内的变化规律和物料平衡、流向分配的研究基础上,继续对该中试A / A / O……
-
-
8种DRDOUSA-摆动驱动器模型,摆动驱动器用于位置感测,带可调液压缓冲器和能补偿间隙的齿轮系统.能源接口位于右侧,旋转角度调整范围-20-6deg摆动角度0-180deg缓冲液压缓冲器,硬性特征曲线,可调节装配位置任何设计结构齿轮齿条机构位置检测用于接近式传感器...
-
-
此为一台组装段Type C 16PIN双排DIP脚组装防水密封O形圈自动机,机台可以一次同时组装两个产品的密封圈,效率高,机台稳定,欢迎连接器行业机械工程师下载参考,机台文档采用STP中性档格式,可使用任意一款3D软件任意版本打开~!
-
此为一台点焊段防水Type C 16PIN内壳与O形圈点焊自动机,机台一次可点焊四个产品,效率高,机台稳定,欢迎连接器行业机械工程师下载参考,机台文档采用STP中性档格式,可使用任意一款3D软件任意版本打开~!
-
-
-
A/O 脱氮技术在焦化废水处理中的应用
对原有的焦化废水处理工艺存在的问题进行了研究,借鉴了国内外同行业在废水处理技术方面取得的经验,采
用了先进的A/O 脱氮技术,对原有的废水处理设施进行了改造,并在实际运行中探索出了最佳的工艺运行条件,缓解了公司所
面临的环保压力
-
-
O系列电子膨胀阀主要用于一拖多变空调室内机,实现制冷流量的自动调节,达到快速制冷、温度精确控制、节能静音等目的,还可用于其他控制。该阀具有可逆性,能实现制冷、制热状态下的流量自动控制。...
-
-
本模型为英国卡迪夫码头建设的教堂模型,模型设计为一座教堂,该模型建筑在英国卡迪夫码头,模型十分漂亮逼真。该模型使用SketchUp8,欢迎喜欢英国卡迪夫码头建设的教堂设计的朋友来下载参考...
-
-
-
ET 200M 分布式 I_O 站操作手册
-
臭氧氧化联合A/A/O 工艺污泥减量的可行性
针对目前污水处理厂污泥产量大、处理处置费用高的问题,该文以A / A / O 工艺构建了模拟城市生活污水小试处理系统,通过添加臭氧研究不同臭氧投加量对出水水质及污泥产率的影响。结果表明在试验进水条件下,系统的稳定污泥浓度为2 000~3 000 mg / L,且当将约50 %产泥量的污泥经臭氧化返回至系统中时,加入臭氧与不加臭氧的两套系统显示出相当的污
水处理能力
-
-
变送器(transmitter)是把传感器的输出信号转变为可被控制器识别的信号(或将传感器输入的非电量转换成电信号同时放大以便供远方测量和控制的信号源)的转换器。传感器和变送器一同构成自动控制的监测信号源。不同的物理量需要不同的传感器和相应的变送器。变送器的种类很多,用在工控仪表上面的变送器主要有温度变送器、压力变送器、流量变送器、电流变送器、电压变送器等等。...
-
中美信托金融大厦桩基拔除工程
拟建中美信托金融大厦项目东至吴淞路,南至北苏州路,西至乍浦路,北至天潼路,地处黄浦江和苏州河交汇处,项目占地面积1.28万平方米,建筑面积12.3万平方米,由两幢高100米和66米的塔楼及五层裙楼和20米深的四层地下空间组成。围护结构采用墙厚1000mm地下连续墙作为基坑围护形式,墙底标高为-51.250m,其中靠近北侧及相邻轨道交通12号线区间隧道的C、D区域主要采用Ф850三轴搅拌桩槽壁加固及墙厚800mm地下连续墙作为基坑围护形式,地连墙墙底及槽壁加固底标高统一为-32.000m。
-
广西信托梧州营业部设计CAD图纸
本资料为广西信托梧州营业部设计CAD图纸,图纸包括:一楼信息点布置图,二楼东厅信息点布置图,三楼信息点布置图等,设计精准,内容详实,可供网友下载参考。
-
北大纵横清江发展信托公司介绍
作用:(一)、降低公司代理成本,提高企业经营效率;(二)、培养并留住优秀的企业经营管理人才,建立股权激励机制;(三)、优化资本结构,使国有资本从一般竞争性行业逐渐退出。
-
-
-
-
CB╱T3818-1999[OO型开式索具螺旋扣KOOD系类全套13种规格使用时一定要严格遵守额定载荷,过度频繁使用和超载使用都是不允许的。特别提醒使用操作人员,起重过程中,起重机械和起重吊具下请勿站人。索具螺旋扣出现以下几种情况请停止使用:1.出现裂纹。2.变形超过10度。3.磨损度超过10%。4.超负荷使用后,请重新检验后使用。...
-
英国SpiraxFT14DN25BSPRL-1475300疏水阀三维模型,可编辑,含参数,可直接用于装配。用于蒸汽冷凝水管路排放,螺纹连接。...